Runco LIGHTSTYLE LS-10D, Руководство по установке и эксплуатации

Страница: 61 / 126

Installation
Runco LS-10d and LS-10HBd Installation/Operation Manual 45
PRE
L
IMINAR
Y
3.11
Installing and
Adjusting the
Anamorphic Lens If you are installing an LS-10 with an anamorphic lens, proceed as follows to install and
adjust the lens.
Attach the anamorphic lens to the bracket using the plastic knobs supplied with the lens.
See Figure 3-20.
Figure 3-20. Attaching the Anamorphic Len s to the Len s Mount
Configure Len s Motor Trigger on DHD Controller (Optional): The anamorphic lens
solution for the LS-10 maintains constant image height independent of the aspect ratio,
while using the full display resolution of the projector. It accomplishes this by moving the
anamorphic lens in front of the primary lens when widescreen material is being viewed.
When the viewer transitions back to 16:9 or 4:3 source material, the anamorphic lens
moves out of the light path.
If you are using a trigger on the DHD Controller to control the lens transport motor,
proceed as follows to configure it for proper operation.
1. Project a 2.35:1 aspect ratio test pattern or other image on the screen.
2. On the DHD Controller remote control or front panel, press MENU .
3. Select S ervice from the Main Menu and enter the Service Menu passcode.
It is extremely important that the primary lens is properly
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
You can skip this step if you connected the lens transport motor to
the
TRIGGER 1 output on the LS-10, as shown in Figure 3-15.
Note
Note
You must enter a passcode to access the Service menu for the first
time after turning on the system.
Note