Runco Crystal CX-42HD, Руководство по установке и эксплуатации

Страница: 53 / 84

Operation
Crystal Series LCD Installation/Operation Manual 39
PRE
L
IMINAR
Y
Sleep Timer: Use the Sleep Timer to turn off the Crystal Series LCD after a specified
interval.
To set the Sleep Timer:
• Select Sleep Timer from the Timer menu and press ENTER .
– OR –
• Press the TIMER OFF button on the remote control.
Use the right- or left-arrow button to select 10, 30, 60, 120 or 180 minutes. Then, press
ENTER or MENU .
Setup Use the controls in the Setup menu to perform advanced image quality adjustments and
access various other Crystal Series LCD features.
OSD Language: Select OSD Language from the Setup menu and press ENTER . Then,
use the up- or down-arrow buttons to select the OSD language (English, French, Spanish,
Portuguese or German). Press
ENTER again to confirm your selection.
OSD Timer: Use the or button to set the OSD Timer. This timer controls how long
the menus remain on-screen after selecting them. Select from 0 to 60 seconds, in
10-second increments. When you set the OSD to 0, the menus remain on-screen until
you hide them by pressing
EXIT .
PC Mode Adjust: To improve the quality of displayed images from a computer or other
VESA-compliant, RGB (480p or higher) source, select PC Mode Adjust and press
ENTER .
• Auto Adjust: Auto Adjust automatically adjusts settings to optimize computer images.
To execute Auto Adjust on command, select Auto Adjust and press ENTER .
• Clock: Use the up- or down-arrow buttons ( , ) to highlight Clock. Then, use the
right-arrow button ( ) to increase the pixel clock rate; use the left-arrow button ( )
to decrease it.
• Phase: Adjust the phase if the image shows shimmer or “horizontal noise.” Pixel phase
adjusts the phase of the pixel sampling clock relative to the incoming signal. The effect
of this control is similar to that of a tracking control on a VCR.
For best results, use a good test pattern such as a smooth gray consisting of a clear
pattern of black and white pixels, or a similar “half on, half off” graphic image. (You may
notice that you can stabilize the image at more than one point. Use either setting in this
case.)
• H Position: Use the up- or down-arrow buttons ( , ) to highlight H Position. Then,
use the right-arrow button ( ) to shift the image to the right; use the left-arrow button
( ) to shift the image to the left.
• V Position: Use the up- or down-arrow buttons ( , ) to highlight V Position. Then,
use the right-arrow button ( ) to shift the image up; use the left-arrow button ( ) to
shift the image down.
To restore the factory-default Clock, Phase and Position settings, select Factory Reset
and press
ENTER .
Setup
OSD Language
OSD Timer
PC Mode Adjust
Overscan
Letterbox Mode
HDMI Audio Input
Film Mode
Motion Compensation
Auto Backlight
HDMI CSC
Baud Rate
SCART
Source Enable
LED Option
System Info
Auto Adjust may take some time to complete, depending on the
characteristics of the incoming signal.
Note