RG-EasyGate Series Hardware Installation Guide V1.28
Connecting Console
Ruijie EG series breakout gateway provides an EIA/TIA-232 asynchronous serial console port, through which the user can
complete the local configuration of the breakout gateway. The attributes of a console are shown in Table 3-1. In case of
WEB based configuration, the console port will be of no use.
Table 3-1 Attributes of the Console Connection:
Parameter
Description
Connector
RJ-45
Interface Standard
Asynchronous
EIA/TIA-232
Baud Rate
Supporting 9600 bps (default), 57600 bps and 115200 bps
Services Supported
1. Command line interface
2. Connection with character terminal
3. Provision of terminal access service as an asynchronous interface
You can configure the console port of a breakout gateway based on the following steps:
Connect one end of the enclosed configuration cable to the console port of device and the other end to the DB-9 male
interface of the microcomputer used for configuring the device.
Checking after the Installation
After completing the mechanical installation of breakout gateway, perform the following checks before powering on the
device:
If the device is installed in a cabinet, check whether the angle bar for device installation is steady. If the device is
installed on the workbench, check whether sufficient room is reversed around the device to ensure heat elimination
and whether the workbench is steady.
Check whether the power supply meets the requirements.
Check whether the earth wire of device is properly connected.
Check whether the device is connected correctly to other devices like the configuration terminal.
