RG-EasyGate Series Hardware Installation Guide V1.28
Basic Configuration of Ruijie EG1000M Breakout Gateway
Table 1-9 Basic Configuration of Ruijie EG1000M Breakout Gateway
Item
Description
DDR2 SDRAM: 4 GB
BOOTROM: 8 MB
FLASH: 512 MB
Storage
SATA Hard Disk: 320 GB
Gigabit Ethernet interface:
Supports 8 pairs of fiber/copper combo ports and all of them
can be switched between the WAN mode and LAN mode. By
default, the interface 0/1, 0/3, 0/5, 0/7 are WAN ports, while the
interface 0/0, 0/2, 0/4, 0/6 are LAN ports.
The copper ports are 10/100/1000 M adaptive and support
automatic recognition of the network cables and the cross-over
cables.
The fiber ports are supported on the 1000BASE-SX/LX/ZX mini
GBIC module.
One management port, which supports 10/100 M adaptive and
automatic recognition of the network cables and the cross-over
cables.
One console port
One USB port
I/O Setup
One SD card
BYPASS
Gigabit copper port hardware BYPASS:
Supports two pairs of the interfaces: 0/0-0/1 and 0/2-0/3;
Supports the two modes of power-off, power-on BYPASS and
the main program configured BYPASS.
Supports fiber BYPASS. (you need to purchase the fiber
BYPASS device.)
Switch Power Module
Supports two RG-PA300I power modules.
Hot-swapping
Supports fan tray hot swapping.
Supports power supply hot swapping.
Interface Standard
Ethernet: 10Base-T/100Base-TX/1000Base-TX,
1000BASE-SX/LX/ZX
Configuration port (console port): RS-232
Dimension (W x H x D)
440 x 88.1 x 420 mm (excluding the foot pad)
