KT332N Cutting &engraving control system user manual V1.1
56
9.2 User parameters
All the user parameters can be modified by the software!
（
1
）
Cutting parameters
（
Only affects for cutting works
）
Fast feed speed
：
This parameter determines the maximum speed of all straight lines
that do not fire during the movement of the machine.
Fast feed acceleration
：
Maximum acceleration of no fire for straight lines. Large idling
speed and idling acceleration settings can shorten the working time of the entire graph,
but the setting is too large, which may cause jitter in the trajectory, which needs to be
considered comprehensively when setting.
Corner speed
：
The speed at sharp corners during cutting also is the lowest speed
during the entire cutting.
Corner acceleration
：
Acceleration at sharp corners when cutting. Setting the turning
speed and turning acceleration too large will make the corner jitter, and setting it too
small will affect the cutting speed.
Cutting acceleration
：
The highest acceleration value of the firing segment during the
entire cutting process.
Cutting mode
：
There are two types: fast cutting and precision cutting. For fast cutting,
the cutting speed is given priority, and for precision cutting, the cutting effect is given
priority.
Acceleration method
：
Divided into T-type acceleration and S-type acceleration. T-type
acceleration will make the whole cutting process faster, but the cutting effect caused by
too fast T-type acceleration mode will be inferior to that of S-type acceleration.
Delay after fast feed
：
If this parameter is 0, no delay is performed after idling,
otherwise the speed is reduced and delayed after idling.
（
2
）
Engraving parameters
（
Only affects for engraving works
）
X axis starting speed
Y-axis starting speed
X-axis acceleration
Y-axis acceleration
The above four parameters are used to set the initial speed and acceleration of the two axes
during scanning. The larger the initial speed and acceleration value, the faster the scan.
Scan step feed speed
：
This parameter is used to control the maximum speed of the
vertical movement of the previous line to the next line in the scanning mode. If the
space between lines is large during scanning, or when the distance between each
block is large when scanning block graphics, and precise positioning of each line or
each block is required, you can set scan wrap Speed is a lower value.
Scan mode
：
General mode and special mode are selectable. If the special mode is
enabled, the laser power should be increased. The lower the spot percentage, the
more the laser power is attenuated. To achieve the same scanning depth, the laser
power should be set higher. The purpose of selecting the special mode is to make the
laser emit light at high power for a short period of time. During deep scanning, the
effect is flat at the bottom. However, it should be noted that if the adjustment of the spot
is not appropriate, this purpose may not be achieved. The mode has a certain effect on