Ruckus Wireless ZoneFlex 901-T504-US31, Руководство по установке

Страница: 47 / 52

T504 AP Installation Guide, 800-71032-001 Rev D
47
Appendix D: Rebooting and Resetting the
T504
o Rebooting and Resetting the AP and CM
o Rebooting and Factory-Resetting the CM
Rebooting and Resetting the AP and CM
CAUTION! Performing this procedure resets the AP and CM parts of the T504 to their factory default
settings.
If you want to reset only the CM component to its factory default settings, then perform the procedure
described in
Rebooting and Factory-Resetting the CM instead.
CAUTION! Resetting the AP and CM to factory default settings erases all the settings that you have
previously configured. Also note that resetting and/or rebooting the AP and CM disrupts all wireless
network communications through this device.
There are different ways to reboot or reset the AP and CM parts of the T504:
o
Using the Reset Button Inside the AP
o Remotely Rebooting and Factory Resetting the AP
Using the Reset Button Inside the AP
You can reset the AP and CM to their factory default settings by pressing the reset button located
under the screw-in reset button and diagnostic Ethernet port access plug on the T504.
1 Make sure that the AP is powered.
2 Use a 7/16’’ (11mm) socket or wrench to remove the screw-in reset button and diagnostic
Ethernet port access plug. See
Figure 6 for the location of the screw-in reset button and diagnostic
Ethernet port plug.
3 Locate the reset button under the access plug. See Figure 23 for the location of the reset button
inside the T504.
D