Ruckus Wireless ZoneFlex 901-T504-US31, Руководство по установке

Страница: 20 / 52

T504 AP Installation Guide, 800-71032-001 Rev D
Installing the T504
20
Dimensions
Table 3. LEDs and reset button/diagnostic Ethernet port (Continued)
No. Label Description
9 -- Reset button and diagnostic Ethernet port -- Use a 7/16’’ (11mm) wrench to remove
the screw-in access plug.
o
After removing the plug, press the reset button for ten seconds to reset the AP
part of the T504 to factory default.
CAUTION: DO NOT DO THIS UNLESS SO INSTRUCTED. Doing this resets the
AP IP address to 192.168.100.2.
o After removing the plug, you can see the diagnostic Ethernet port. This port is
used for diagnostics and/or initial configuration.
LED Startup Sequence
The startup sequence from factory default state to operational state is as follows:
1.
At power on, the Power LED is red, then blinking green during bootup.
2. CM DS LED blinks while finding CM downstream link, then solid once complete.
3. CM US LED blinks while finding CM upstream link, then solid once complete.
4. Online LED blinks while getting new config from CMTS, and solid once configuration is
complete.
5. Power LED is solid green once an IP address is received.
6. Once the AP is approved on the controller, the DIR LED starts blinking, indicating firmware
downloading.
Note: If the AP was preconfigured at the factory and does not need a firmware upgrade, this
step is skipped.
7. Once firmware upgrade is complete, the AP reboots and the Power LED turns red, then
blinking green, then solid green once reboot is complete.
8. AIR, 2.4 GHz and 5 GHz LEDs are the same as other Ruckus APs: Amber when SSID is up,
green when clients connected to the radio. The AIR LED indicates Mesh AP upstream
connectivity; therefore it will not generally be lit on a cable modem AP, whose backhaul should
be the cable modem rather than a mesh link.