Ruckus Wireless ZoneFlex 7762-T, Руководство по установке

Страница: 39 / 62

35
Deploying the Access Point
Check the TR069 Status (FlexMaster Management Only)
Check the TR069 Status (FlexMaster Management
Only)
If you configured the Access Point to report to a FlexMaster server on the network, make
sure you verify that it can successfully communicate with the FlexMaster server. You can
do this by checking the TR069 status on the Access Point’s Web interface.
1. Log in to the Access Point’s Web interface.
2. Go to the Administration > Management page.
3. Scroll down to the TR069 Status section.
4. Check the value for Last successful contact . If it shows a date in green, this indicates
that the Access Point was able to communicate successfully with FlexMaster.
Disconnect the Access Point from the Network
1. Disconnect the Access Point from the power source.
2. Disconnect the Ethernet cable that runs to the Access Point’s RJ45 port from your
network’s router or switch.
You are now ready to deploy the Access Point to its permanent mounting location.
6
Deploying the Access Point
In this step, you will connect the Access Point to the network from its mounting location.
Step 1: Connect and Seal the RJ-45 Cable
The Access Point comes with two sets of RJ-45 waterproof connectors. To complete this
step, you will need one RJ-45 cable (two if you plan to use both the PoE IN and PoE OUT
ports) and the RJ-45 waterproof connector assembly that is supplied with the AP.
1. Take out one of the two plastic bags containing the RJ-45 waterproof connector
assembly.
2. Feed the end of the RJ-45 cable through the sealing nut, rubber-O ring, and clamping
ring assembly (in the same order). See
Figure 27 .