16
Configuring the Access Point
Configuring for Management by ZoneDirector
■
Two Ethernet cables
■
PoE injector (if not supplied with the Access Point, you can purchase a third party
802.3at-compliant PoE injector or switch)
■
6mm Phillips screwdriver
If you are planning to power the Access Point using a 12v DC connection, you will also
need the following:
■
One 0.195” to 0.265” diameter DC cable
■
12v DC, 1.5A DC power source (for example, a battery)
Step 1: Connect the Cables to the Access Point
The procedure for connecting cables to the Access Point depends on the power source
that you will be using. You can do one of the following:
■
Use Power Over Ethernet
■
Use DC Power
NOTE:
You only need to connect one type of power source at this point, even if you are
planning to use both PoE and DC power in your final deployment.
Use Power Over Ethernet
1.
Take out the PoE injector and the power adapter from the Access Point package.
2.
Obtain two Cat5e or better Ethernet cables.
3.
Connect one end of one Ethernet cable to the
AP/BRIDGE
port on the PoE injector,
and then connect the other end to the
PoE IN
port on the Access Point.
4.
Connect one end of the other Ethernet cable to the
NETWORK
port on the PoE
injector, and then connect the other end to ZoneDirector directly or through a hub.
5.
Connect the power jack to the
DC 48V IN
connector on the PoE injector, and then
plug the power adapter to a power source. The single LED on the PoE injector turns
green.
6.
Check the
Power LED
on the side of the Access Point. Initially, the LED will turn
red
as
the AP powers on. After it completes the power-on sequence, the LED will turn
green
.
Содержание ZoneFlex 7762-T
Страница 2: ......
Страница 62: ...58 What to Do Next Read Related Documentation...
