Ruckus ICX 7450 Switch Hardware Installation Guide
81
Part Number: 53-1003899-07
Time and items required
Replacing an expansion module or service module in the Ruckus ICX 7450 should take less than two minutes to complete.
You need the following items to replace an expansion module or service module in the Ruckus ICX 7450:
•
A new expansion module or service module
•
A #1 Phillips screwdriver
Installing or replacing an expansion module or service module
Complete the following steps to install or replace an expansion module or service module in the Ruckus ICX 7450.
1.
Power off the switch.
2.
If replacing an expansion module:
a.
Pull the release latch lever on the module into its open position.
b.
Using a Phillips screwdriver, unscrew the two captive screws on the expansion module.
c.
Remove the expansion module from the chassis by pulling the handle on the expansion module out and away from the
chassis.
3.
If installing a new expansion module into a slot covered with a filler panel:
a.
Using a Phillips screwdriver, unscrew the captive screws on the filler panel.
b.
Remove the filler panel.
4.
Before opening the package that contains the new expansion module, touch the bag to the switch casing to discharge any
potential static electricity. It is recommended that you wear an ESD wrist strap during installation.
5.
Remove the expansion module from the anti-static shielded bag.
6.
Holding the expansion module level, guide it into the carrier rails on each side and gently push it all the way into the slot, ensuring
that it firmly engages with the connector.
7.
When you are sure the expansion module has properly engaged the connector, tighten the captive screws to secure the
expansion module in the slot.
8.
Push the release latch lever on the module into its closed position.
9.
Power on the switch.
10. Verify correct installation by running the
show module
command.
CAUTION
The expansion modules are not hot-swappable.
CAUTION
Do not force the installation. If the expansion module does not slide in easily, ensure that it is correctly oriented
before continuing.
CAUTION
Empty expansion module slots must be covered using filler panels.
