40
Ruckus ICX 7450 Switch Hardware Installation Guide
Part Number: 53-1003899-07
Installing the Ruckus ICX 7450
Installing the Universal Four-Post Rack Kit (XBR-R000296)
3.
Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 30
Attaching the rear brackets to the front rack posts
Installing the Universal Four-Post Rack Kit (XBR-R000296)
Use the following instructions to install a device in EIA racks that are between L-12.7 to 81.28 cm deep (L-5.0 to 32.0 in.), where L is the
chassis depth, using the Universal Four-Post Rack Kit (XBR-R000296).
There are two ways you can mount the device in a four-post rack:
•
With the port side flush with the front posts
•
With the nonport side flush with the rear posts in a recessed position
A recessed position allows a more gradual bend in the fiber-optic cables connected to the switch and less interference in the aisle at the
front of the rack.
NOTE
Although this document describes how to install both single height (1U) and double height (2U) switches, the illustrations show a
1U switch as a typical installation.
NOTE
Hardware devices illustrated in these procedures are only for reference and may not depict the device you are installing into the
rack.
1
Screws, 10-32 x 5/8-in., panhead Phillips
2
Retainer nuts, 10-32
