Ruck RLI 1200 EC, Сборка и руководство по эксплуатации

Страница: 7 / 58

English
www.ruck.eu 7
2.5. Adhere to the following instructions
• Observe the provisions for accident prevention and environmental protection for the country
where the product is used and at the workplace.
• Persons who assemble, operate, disassemble or maintain
ruck
products must not consume
any alcohol, drugs or pharmaceuticals that may affect their ability to respond.
• Responsibilities for the operation, maintenance and regulation of the product should be
clearly determined and observed so that there can be no unclear areas of responsibility
with regard to safety.
• Never overload the product. Never use it as a handle or step. Do not place anything on it.
• The warranty only applies to the delivered con fi guration.
• The warranty will not apply if the product is incorrectly assembled or handled or not used
as intended.
2.5.1. General instructions
2.5.2. During installation
• Disconnect all of the product‘s poles from the mains before installing the product or connecting
or removing plugs. Make sure that the product cannot be switched back on again.
• Lay cables and lines so that they cannot be damaged and no one can trip over them.
• Before commissioning, make sure that all gaskets and seals in the plug-in connections are
correctly
fi tted and undamaged in order to prevent fl uids and foreign matter getting into the
product.
• Information signs must not be changed or removed.
• Make sure that all electrical connections are either used or covered. Commission the product
only if it is installed completely.
• The power switch must be always fully functional and easy accessible!
2.5.3. During commissioning
2.5.4. During operation
• Only authorized personnel is allowed to operate the setting mechanisms of the components
or parts, under the provision that the system is used as intended.
• In an emergency, or if there is a fault, or other irregularities, switch the equipment off and
make sure it cannot be switched back on again.
• The technical data given on the rating plate must not be exceeded.
2.5.5. During cleaning
• Never use solvents or aggressive detergents. Only clean the product using a slightly damp,
lint-free cloth. Only use water to do this and, if necessary, a mild detergent.
• Do not use a high-pressure cleaner for cleaning.
• After cleaning, make sure that the product is working correctly again.
2.5.6. During maintenance and repair
• If operated correctly,
ruck
products only require a minimum amount of maintenance.
Please follow all of the instructions given in section 10 in this respect.
• Make sure that no connections or components are loosened unless the device is discon-
nected from the mains. Make sure that the equipment cannot be switched back on again.
• Individual components must not be interchanged. For example, the components intended
for one product may not be used for other products.
2.5.7. Disposal
• Dispose the product in accordance with the currently applicable national regulations in
your country.