Ruck FFH 125 EC 10, Сборка и руководство по эксплуатации

Страница: 22 / 34

English
12.2. Disposal
12.1. Disassembling the product.
12. Dismantling and disposal
Bei der Außerbetriebsetzung und Demontage sind die Sicherheitshinweise gemäß Kapitel 2 bis 8
und Kapitel 12 zu beachten.
Dismantle the unit as follows:
•
Risk of injury if dismantled under hazardous voltage!
»
If you do not switch off the voltage before starting to dismantle the unit you may injure yourself
and damage the product or parts of the installation.
→
Make sure that the relevant parts of the installation have been disconnected from the voltage supply.
Das achtlose Entsorgen des Gerätes kann zu Umweltverschmutzungen führen.
Entsorgen Sie das Gerät daher nach den nationalen Bestimmungen Ihres Landes.
11. Expansion and reconfiguration
The unit must not be reconfigured.
ruck
Ventilatoren‘s warranty only applies for the configuration delivered.
The warranty will cease to apply after any reconfiguration or expansion.
The battery‘s operating capacity is checked when voltage is applied to the unit.
A dead battery is indicated by a battery symbol in the status display. Change the battery as follows:
•
Remove the control cable (1) from the control unit.
•
Open the control unit by removing the cover (2).
•
The holder (3) for the battery is on the board. Remove the battery and replace it with a new one
as shown in Fig. 15 C.
•
The control unit can now be closed again and the control cable connected again.
•
You only have to reset the current time (see Section 9.3.1). The battery symbol disappears from
the status display. Your control unit is fully functional again.
Note: requires a 3 V lithium CR 1616 button cell battery.
10.3.2. Changing the battery
Fig. 15:
(1) Control cable
(2) Control unit cover
(3) Battery holder
Status display
Reset the display:
22
C)
2
1
A) B)
01
125987
01
125987
3
21,0° 1
21,0° 1
Tel. +49 7930 9211-0 Fax. +49 7930 9211-150