Ruck FFH 125 EC 10, Сборка и руководство по эксплуатации

Страница: 19 / 34

English
9.3.3. Parameter settings Menu
You move to the parameter settings menu by pressing the ON/OFF button, which must be held down
for approx. 7 seconds.
The display then changes to „P 1 MIN-VALUE“.
The individual menu points can be called up with buttons A (▲ and ▼) on the control unit. The values
can be changed with buttons B (▲ and ▼).
Press the „Mode button“ (M) to go back to the starting functions.
P 1 Minimum set-point value
Parameter P 1 gives the minimum set-point temperature that can be set on the control unit. Values
between 5 °C and 20 °C can be selected.
The default setting is 17 °C.
P 2 Maximum set-point value
Parameter P 2 gives the maximum set-point temperature than can be set on the control unit. Values
between 21 °C and 30 °C can be selected.
The default setting is 28 °C.
P 3 Enable
Switching the unit on and off with an external contact.
Contact open. The unit is switched off.
Contact closed. The unit is switched on / ready for operation.
The unit can only be switched on if the contact is closed. If the contact is
open the display will show „NOT ENABLE“.
The contact should be closed and then acknowledged with button B (▲).
The default mode is AUTOMATIC.
P 6 Heating stage selection
There are three heating stages to choose from:
No heating is added.
The setting depends upon the type of device. The values for the setting
are given in Section 14 „Technical Data“.
The setting depends upon the type of device. The values for the setting
are given in Section 14 „Technical Data“.
P 5 Room or supply temperature control
The room or supply air temperature controller compares the air temperature measured on the room
or supply air temperature sensor with the set-point temperature set on the control unit. In the case of
heating, a difference between the set-point and actual temperature causes the controller to increase
or reduce the heat output.
With room temperature control, any external heat source in the room will
be taken into account and compensated for by a correction to the supply
air temperature. The room temperature sensor is in the control unit.
With supply air temperature control, the external heat source is not taken
into account.
P 4 Filter‘s hours of operation
With parameter P 4, the air filter‘s operating capacity can be given in hours until it has to be changed.
Value x 10 in hours (e.g. value 100 = 1000 hours of operation).
When the set number of hours is reached, the filter display will remind
you that the air filter has to be changed.
To reset the filter display, after the filter change, press buttons A (▲ and
▼) until the filter display disappears. The filter change counter will then
increase by one.
7 sec
P2 MAX-VALUE
28,0°
P3 ENABLE
AUTOMATED
P4 OPERAT.HOURS
FILTER 100
P5
ROOMTEMP.CONTROL
P6 HEATER POWER
4,5 - 9 KW
P1 MIN-VALUE
17,0°
P6 HEATER POWER
0 KW
P6 HEATER POWER
3 KW
P6 HEATER POWER
4,5 - 9 KW
P5
ROOMTEMP.CONTROL
P5
SUP.AIR TEMP.CON
21,0° 1
FILTER
P3 ENABLE
AUTOMATED
P3 ENABLE
ACKNOWLEDGED
19

A


B


A


B


A


B


A


B


A


B


A


B

www.ruck.eu