RTS BTR-80N, Руководство по эксплуатации

Страница: 37 / 90

BTR-80N, TR-80N, TR-82N Operation 35
5.
Press SET .

The receiver 1 squelch setting starts flashing.
6.
Using the UP/DOWN arrow buttons, adjust the setting .
7.
When finished, press SET .
8.
Repeat steps six (6) and seven (7) to set the remaining
receivers.
9.
When finished, press SET .

The Base Main selection menu appears.
10.
Press MENU twice.

The base menu select menu screen appears.
NOTE: The base defaults back to the status screen if no
action is taken after five (5) minutes.
The base employs two (2) different types of squelches. A fast
acting noise type squelch and a slower data squelch. For audio
to be received by the base, both a good signal-to-noise audio
signal (with a noise threshold set via the user squelch settings
above) and a valid data stream must be detected.
Stage Announce Level
The Stage Announce software option allows the user to adjust
the audio output level of the rear panel stage announce jack.
.
FIGURE 46.
Stage Announce
To set the stage announce level , do the following:
1.
From the status screen, press MENU .
2.
Using the UP/DOWN arrow buttons, select Base Main .
3.
Press SET .
4.
Using the UP/DOWN arrow buttons, select MORE... .
5.
Press the DOWN arrow button .

The stage announce level flashes.
6.
Using the UP/DOWN arrow buttons, adjust the setting .
NOTE: Each press of the button is a 6dB step increase or
decrease of volume.
7.
When finished, press SET .
8.
Step through the other settings in the screen by pressing
SET .

After the last option on the screen, the base main selection
menu appears.
9.
Press MENU twice to go back to the status screen.
NOTE: The base defaults back to the status screen if no
action is taken after five (5) minutes.
Antenna Power
Antenna Power can be enabled or disabled. If antenna power is
enabled, 9VDC is placed on the center pin of the receive
antenna. The purpose of this voltage is to power in-line low
noise amplifiers on the receive coaxial cable in order to
compensate for excessive RF signal loss due to long cable runs.
Specifications of the power on the antenna jack:
Options: On/Off (Off=Default)
Voltage: 9VDC
Current: 100mA max.
Protection: Current is limited to 100mA

Base can withstand a continuous short to
ground without damage.
.
FIGURE 47.
Antenna Power