RTS BTR-80N, Руководство по эксплуатации

Страница: 13 / 90

BTR-80N, TR-80N, TR-82N Introduction 15
.
FIGURE 5.
TR-80N Rear Panel/Connector/Antennas
1.
MENU and SET buttons - Use to select menus and set
options on the LCD.
2.
LCD (Liquid Crystal Display)
3.
UP and DOWN buttons - Use to select beltpack options
on the LCD.
4.
Programming Connector - Use to update software in unit.
5.
Headset Connector - Male XLR or female XLR connector.
A dynamic or electret headset microphone is automatically
detected by the beltpack and a bias voltage supplied, if
needed.
6.
Battery Latch - Press down to release the battery pack.
While holding the latch down, slide the battery pack about
1/8 inch back toward the latch until it stops, then lift it out.
7.
Receive Antenna - Screw type 1/4-wave replaceable
antenna. The color dot on the screw end of the antenna must
match color dot on the antenna receptacle.
8.
Transmit Antenna - Screw type 1/4-wave replaceable
antenna. Color dot on the screw end of the antenna must
match color dot on antenna receptacle.
FIGURE 6.
Headset Jack Wiring
IMPORTANT: Microphone gain and transmit mode is
set via software menus.