RTS BTR-80N, Руководство по эксплуатации

Страница: 17 / 90

BTR-80N, TR-80N, TR-82N Introduction 19
1.
MENU and SET buttons - Used to select menus and set
options on the LCD.
2.
LCD (Liquid Crystal Display)
3.
UP and DOWN buttons - Used to select beltpack options
on the LCD.
4.
Programming Connector - Used to update software in
unit.
5.
Auxiliary Input Audio Jack - 1/85” (3.5mm) mono input
jack. Local only to beltpack.
6.
Headset Connector - Male XLR connector or female
XLR. A dynamic or electret headset microphone is
automatically detected by the beltpack and a bias voltage
supplied, if needed. 4-pin Telex/RTS units are monaural. 5-
pin Telex/RTS units have a software setup to select if XLR
pin 3 or 5 is the channel 2 output and if pin 3 is ground.
7.
Battery Latch - Press down to release the battery pack.
While the latch is held down, slide the battery pack about 1/
8 inch back, toward the latch, until it stops, then lift it out.
8.
Receive Antenna - Screw type 1/4-wave replaceable
antenna. The color dot on the screw end of the antenna must
match color dot on the antenna receptacle.
9.
Transmit Antenna - Screw type 1/4-wave replaceable
antenna. The color dot on the screw end of the antenna must
match color dot on the antenna receptacle.
IMPORTANT: Microphone gain and transmit mode is
set via software menus.
FIGURE 8.
TR-82N Rear Panel/ Connector/Antennas
FIGURE 9.
Handset Jack Wiring