RTS BTR-800, Руководство по эксплуатации

Страница: 85 / 88

CHAPTER 14
Certification Information
CAUTION: Changes or modifications made by the user could void the user’s authority to operate the equipment.
NOTE: This wireless microphone system can be configured for both FCC Part 15 (unlicensed) and FCC Part 74
(licensed) operation. When shipped from the factory, this wireless microphone system is configured for
unlicensed operation, and will operate at a power level not to exceed 50 milliwatts, which meets FCC Part 15
requirements. If unlicensed users operate this device in excess of 50 milliwatts, harmful interference may result
and the unlicensed user will be subject to substantial monetary forfeitures and other FCC sanctions. The wireless
microphone system may be operated by holders of a valid FCC license in the Low Power Auxiliary Radio
Service under Part 74 of FCC Rules, at power levels between 50 milliwatts and 250 milliwatts.
1.
Use only manufacturer or dealer supplied antenna. Antenna minimum safe distance, as calculated from FCC requirements,
is 4.8 cm. However, the FCC default for the minimum safe distance is 20 cm. Antenna gain: zero dBd referenced to a
dipole.
2.
The FEDERAL COMMUNICATIONS COMMISSION has adopted a safety standard for human exposure to RF (Radio
Frequency) energy, which is below the OSHA (Occupational Safety and Health Act) limits.
3.
To comply with current FCC RF Exposure limits, the antenna must be installed at or exceeding the minimum safe distance
shown here, and in accordance with the requirements of the antenna manufacturer or supplier.
4.
Antenna substitution: Do Not substitute any antenna for the one supplied by or recommended by the manufacturer or
radio dealer. You may be exposing person or persons to harmful radio frequency radiation. You may contact your radio
dealer or the manufacturer for further instructions.
5.
WARNING : Maintain a separation distance from the antenna to person(s) of at least 20 cm.
You, as the qualified end-user of this radio device must control the exposure conditions of bystanders to ensure that the
minimum separation distance (above) is maintained between the antenna and nearby persons for satisfying RF Exposure
compliance.
The operation of this transmitter must satisfy the requirements of the Occupational/Controlled Exposure Environment for
work-related use. Transmit only when person(s) are at least the minimum distance from the properly installed, externally
mounted antenna.
FCC
The RTS BTR-800, TR-800, and the TR-825 Transmitter/Receiver are Type Accepted under United States Federal
Communications Commission Part 74. Part 74 licensing of the equipment is the User’s responsibility and licensibility depends
on the user’s classification, users application, and frequency selected. Bosch strongly urges the user to contact the appropriate
telecommunications authority for any desired clarification.
The device complies with Part 15 of the FCC Rules. this device complies with part 15 of the FCC Rules. Operation is subject
to the following tow conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference that may cause undesired operation.
Mandatory Safety Instructions
to Base Station Installers and Users