DM5210 analog input module 1-1 RTD Embedded Technologies, Inc.
CHAPTER 1
MODULE SETTINGS
The 210/5210 has jumper and switch settings you can change if
necessary for your application. The module is factory-configured
with the settings listed in Table 1-1 and shown on the module
diagram at the beginning of this chapter. Should you need to
change these settings, use these easy-to-follow instructions before
you install the module in your system.
By installing resistor packs and soldering jumpers in the de-
sired locations in the associated pads as described near the end of
the chapter, you can configure 16 of your digital I/O lines to be
pulled up or pulled down.
The final section describes how to install two resistors and a
trimpot to set the resistor configurable gain to the value required
for your application. A pad for installing a capacitor is also in-
cluded in the gain circuitry for creating a low-pass filter.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
