DT2350 2-Channel Strain Gauge
Load Cell Data Logger Manual
ELM0099A
RST Instruments Ltd.
Page 8
12
Connect the supplied USB connector cable to the DT2350 data logger and
computer’s USB port.
13
Launch the DT Logger Host software. Wait for the port and status indicator to
turn green. Refer to Figure 3-9. Refer to Section 5 if the indicators do not turn
green.
F
IGURE
3-9
P
ORT AND STATUS INDICATORS
The DT2350 is now ready to be configured for data logging.
4
L
OGGER
C
ONFIGURATION
The following sections detail how to correctly configure the DT2350 for data logging.
It is important to ensure the logger is properly configured before beginning data
collection.
4.1
L
OGGING
T
AB
Configure the logger in the Logging Tab prior to data collection.
Refer to Figure 4-1 and Table 4-1 for Logging settings and descriptions.
NOTE:
S
OME LOGGER CONFIGURATION PARAMETERS WILL BE CONTROLLED BY THE
RTU
BASE STATION WHEN THE LOGGER IS IN
RSTAR
ENABLED MODE
.
A
NY
SUCH PARAMETERS WILL BE INACCESSIBLE BY THE
DT
L
OGGER
H
OST
S
OFTWARE
.
