RS RS-1384, Инструкция по эксплуатации

Страница: 11 / 15

OPERATION INSTRUCTION / EN
09/16/11 Version No. 00 EN-9
(f). Press or key to set the desired alarm high limit value, the resolution of setting value
is 0.1 degree regardless of the temperature units.
(g). Press “
↵ ↵↵ ↵
” key to store the alarm high limit value and to enter the alarm low limit value
setting, the symbol “ ” is displayed.
(h). Press or key to set the desired alarm low limit value, the resolution of setting value
is 0.1 degree regardless of the temperature units.
(i). Press “
↵ ↵↵ ↵
” key to store alarm low limit value. Repeat procedures (c) to (i) to store
individual alarm High / Low limit values for T1, T2, T3 and T4.
(j). Press “SET” key to exit this mode.
(k). Press “ALARM” key to enter the alarm function, the “ALARM” symbol is displayed.
When the measured temperature value exceeds the setting High temperature value
(the “
” symbol will flashing display.) or below the setting Low temperature value (the
“ ” symbol will flashing display.) a beep will sound once every 4 seconds.
(l). Press “ALARM” key again to exit the alarm function.
4-2 Setting the Thermocouple Type
1. Press “ ” key to turn on the meter.
2. Press “TYPE” key to enter the thermocouple type choices.
The currently selected thermocouple type blinks.
3. Press
⊳
or key to select the desired T1, T2, T3 or T4.
4. Press or key until the thermocouple type you want appears on the display.
5. Press “
↵
↵↵
↵
” key to store the thermocouple type. Repeat procedures (3) to (5) to store
individual thermocouple types for T1, T2, T3 and T4.
6. Press “TYPE” key again to exit.
4-3 Temperature Measurement
1. Press “ ” key to turn on the thermometer.
2. Plug the thermocouple(s) into the thermocouple input. If no thermocouple is plugged into
the selected input or the thermocouple is “open”, the display will show “- - -”.
3. Press “° C / ° F” key to desired temperature scale.
4. Perform measurements by contacting the object being measured with the probe sensor.
5. Read the temperature on the display. The display shows “OL” (overload) or “Un” (under
range) when the temperature being measured is outside the meter valid range.
4-4 Maximum (MAX), Minimum (MIN) Recording Measurement
1. Press “MAX MIN” key to enter the recording mode, the “ REC ” symbol is displayed.
2. Press “MAX MIN” key to scroll through the display of the maximum (REC MAX), minimum
(REC MIN), maximum minus minimum (REC MAX-MIN) and current REC) reading.
3. Press “HOLD” key to paused recording, the “H” symbol is displayed, press “HOLD” key
again to resume recording.
4. Press “MAX MIN” key for 2 seconds to exit this mode.