RS Technical Services Omni II 10-1620, Руководство по эксплуатации

Страница: 5 / 15

Document Number 900-20571 Rev. A 5
Operator and Equipment Safety
CAUTION: NEVER HOOK UP OR DISCONNECT EQUIPMENT WITH
POWER TURNED ON!
It is important to be familiar with operations, maintenance, and safety issues
when working with RST equipment.
Read the entire manual before operating the equipment.
The Inspection System requires a steady supply of 120VAC to operate properly.
Before starting of the generator or connecting shore power, make sure that ALL
equipment has been turned
OFF. Turn down the controls for camera power and
cable reel speed. After all equipment has been checked, connect the shore
power cord.
If a generator is to be used, allow the generator to warm up for a few minutes.
Note: Diesel generators use a different control panel that is separate from the
controller power supply. Refer to the appropriate generator operator’s manual for
starting.
To prevent personal injury or damage to equipment, turn off Camera power .
When making electrical connections, width adjustments and when maintaining
the tractor or camera, disconnect all power to the control station before servicing.
Caution: Before turning on equipment, plug the Auxiliary Control
Box into the Auxiliary Control jack on the controller power supply.
Caution: Route cords away from traffic or wet areas to avoid tripping on
power cords.
Inspect all transport, camera, lighting cables, and bridles before and after each
use. Replace any broken, worn or frayed bridles or cables.
Always use care when near an open manhole, and when climbing in or out of a
TV inspection vehicle. The tractor and camera assembly can be placed into the
pipeline
without personnel entering the manhole. Use proper lifting ropes,
cranes and winches for lifting equipment in/out of pipes.