Y
M
ard
aster
Turnout Controller - Lamp Driver - Power Switcher
RR-Concepts.com
1
2
3
4
5
6
20
19
18
17
16
15
7
11
8
12
9
13
10
14
Common
Suggested
f for track
connections
Switch A
Sensor
Track connections not shown. AC, DC, or DCC trains are controlled.
Make sure to program the YardMaster for the desired time delay.
When the power supply unit is turned on the train should run. If it does not then trigger
the alternate sensor by briefly touching contancts 3 and 4 together with a piece of wire.
This is a one-time operation since the YardMaster will remember the switch state when it
is power cycled
Change direction of train as required. The YardMaster will operate in both directions.
Adding a signal light is optional, but adds to the fun.
Using wire nuts, a clever re-arrangement of wires would only require 4 track connections.
Station Stop Hookup Diagram for a Track Section
Place MAGNET
on bottom of engine.
Track power provides
power to YardMaster
RR-Concepts.com
Add this to a remote location on your railroad.
Isolators
Station
Stop
