Track Isolators, 4 required.
Attach to Left rail
Y
M
ard
aster
Turnout Controller - Lamp Driver - Power Switcher
RR-Concepts.com
1
2
3
4
5
6
20
19
18
17
16
15
7
11
8
12
9
13
10
14
TO
S
TURNOUT
Accessories Input
Power
Switch B Terminals
Switch A Terminals
At
o
tac
s
h t I
o
late
d
L
e
ft
R
a
il
Attac
at
h
o
to Is l
L
ed eft R
ai
l
Alternating Trains Hookup Diagram
This hookup will allow two trains to alternate. When one train enters a siding it will
trigger a sensor which will switch power to the other track. The other train will then run.
Both turnouts are wired in parallel and attached to the TURNOUT terminals of the YardMaster.
The exiting turnout can be powered or non-powered.
The YardMaster will switch when the train is clear of the sensor to prevent the train from
parking on the sensor.
Place the sensor such that the train stops before reaching the isolator. The sensors have no polarity.
Clear any time delay programming if it has been set. (See manual) If acceleration, deceleration, or
a station stop is desired consider adding a StationMaster to this hookup.
For back-and-forth alternating trains add an additional YardMaster or a StationMaster/Reverser.
For each train to do a complete back-and-forth operation before switching program the lap
count to 2. This will cause the YardMaster to ignore every other sensor.
See http://www.StationMaster.net for more info.
RR-Concepts.com
Suggested
f for track
connections
Alternate
Sensor
Alternate
Sensor
