RPB T-Link, Инструкция по эксплуатации

Страница: 6 / 56

6
®
FIGURE 1.1

1. RESPIRATOR
HELMET
ASSEMBLY
 2. BREATHING
TUBE
ASSEMBLY
 3. AIR SUPPLY
PAPR
RESPIRATOR COMPONENT DIAGRAM - PAPR
CAUTIONS AND LIMITATIONS
POWERED AIR
A. Not for use in atmospheres containing
less than 21% ±1% oxygen.
B. Not for use in atmospheres immediately
dangerous to life or health.
C. Do not exceed maximum use
concentrations established by regulatory
standards.
F. Do not use powered air-purifying
respirators if airflow is less than 115 lpm
(4 cfm) for tight fitting face pieces or 170
lpm (6 cfm) for hoods and/or helmets.
H. Follow established cartridge and canister
change schedules or observe ESLI to
ensure that cartridge and canisters are
replaced before breakthrough occurs.
I. Contains electrical parts that may cause
an ignition in flammable or explosive
atmospheres.
J. Failure to properly use and maintain this
product could result in injury or death.
L. Follow the manufacturer’s User’s
Instructions for changing cartridges,
canister and/or filters.
M. All approved respirators shall be
selected, fitted, used and maintained in
accordance with applicable regulations.
N. Never substitute, modify, add or omit
parts. Use only exact replacement parts
in the configuration as specified by the
manufacturer.
O. Refer to user’s instructions, and/or
maintenance manuals for information
on use and maintenance of these
respirators.
P. This respirator is not evaluated as a
surgical mask..
The RPB
®
T-LINK
®
Respirator consists of 3 main components, as shown in Figure 1.1. All 3
components must be present and properly assembled to constitute a complete approved to
EN 12941:1998 +A1: 2003 +A2: 2008 as power air purifying respirator.