RPB T-Link, Инструкция по эксплуатации

Страница: 23 / 56

23
DONNING YOUR HELMET
Once you have completed the set up, you are ready to fit your RPB
®
T-LINK
®
Respirator.
Firstly, check inside the hood and helmet to ensure that it is free of dust, dirt or contaminants.
Then open the bottom of the cape or face seal, with the air flowing from the air source, put
the respirator onto your head. Pull the hood down, tighten the head harness ratchet to fit,
then make sure the neck seal is sealing around your neck. Tuck the inner bib in under you
coveralls or other outer garment. Pull the outer bib down over your shoulders and make sure
it is laying flat on your chest and back so that it does not get in the way of your work.
DONNING AND DOFFING
Open the bottom of the hood with the
air flowing from the air source, put the
respirator onto your head. Make sure the
hood is centered on your head. Pull the hood down, tighten the head
harness ratchet to fit, and make sure the
neck seal is sealing around your neck,
making sure the elastic is tied securely.
Tuck the inner bib into the collar of your
shirt, coveralls, or protective gear to prevent
contaminants from entering the hood. Pull
the outer bib down. Fasten the flow control device belt around
your waist over hip.
FIGURE 11.1
FIGURE 11.2
FIGURE 11.3 FIGURE 11.4