26
PX4 AIR
®
the fan motor housing. Do not wash filters. If they are dirty or contaminated, dispose them
according to your company disposal policy and replace with new filters.
DO NOT submerse in water or use solvents on any parts of the PX4
AIR
®
. This device has electrical components and could cause injury
if put in contact with water.
9.
BELT LOOPS/SUPPORTS: Check the Belt Supports and Belt Loops for cracks. If cracks or
excessive wear is present, they should be replaced. To replace the Belt Supports (03-965)
and the Belt Loops (03-924), unthread the Belt from the Belt Supports and the Belt Loops.
Remove the Belt Loops by removing the two screws in each Belt Loop. Remove the old Belt
Supports and place the new ones. Place the new Belt Loops and screw in tight until secure.
Do not over tighten.
FIGURE 8.1
WARNING
STORAGE
The PX4 AIR
®
should not be transported or stored with the filter or battery attached if not being
used for long periods of time, store in a clean, dry environment, away from direct heat sources
between -10° C and +45° C (14° F and 114° F), at a relative humidity of less than 90%.
All batteries must be transported or stored in a cool dry atmosphere. DO NOT store a battery in
ambient temperatures that exceed 45°C (114°F). It is recommended that the battery is stored at
-10° C to 45° C (14° F to 114° F) as the optimal temperature range for storage, to maximise the life
of the battery.
All filters must be transported or stored in an airtight plastic bag or container so that they are not
exposed to contamination. Partially used filters should also be stored in an air tight plastic bag so
that contaminants are contained.
RESPIRATOR SETUP AND CARE
CONTINUED
