ERGOMETER CITY 200
27
MONTAGE
6 Assembly of the handlebars and Computer
Make fast the handlebar (7) with the handlebar covering (33), a washer (45), and
the T-screw (37) on the handlebar column (6).
Loosen the 4 screws (48) from the backside of the computer (10).Insert the upper
computer cable (51) into the cabel on the back side of the computer (10). Make fast
the computer (10) with the 4 screws (48) to the handlebar column (6).
Insert the pulse cable (4) into the socket on the back side of the computer.
It requires no batteries in the computer.
55
51
10
6
7
48
33 45 37
28
29 42
Warnung
Achtung
Hinweis
7 Assembly of the water bottle holder
Make fast the water bottle holder (29) with two screws (42) on the handlebar column (6). Insert the water bottle (28) in
the water bottle holder.
When the water bottle is in reach you always have enough fluids at your disposal.
Warnung
Achtung
Hinweis
8 Supply and end control of current
Insert the electrical cable (56) into the outlet on the backside of the machine. Insert the plug into a normally
installed insulated wall socket.
➞
In order to move the machine, use the built-in caster on the forward brace.
➞
Recheck the tight fit and the proper condition of the bindings. The machine is built with them and is ready for use.
➞
Before you begin exercising, read and follow the safety instructions described on page 2 and the exercise instructions.
➞
Observe and follow without exception all of the safety instructions listed in the chapter on safety.
➞
The ergometer must only be powered with SELV (Safety Extra Low Volltage) and must be used with the power supply LK- D 060100.
GB
35316_Ergometer City_BDA.indd 27
10.02.15 12:30
