37
RVV Gen II KO Service and Parts Manual
SECTION 3: Vender Programming
Over-ride Switch
If the controller is equipped with a key switch, it can
be used to override some of the settings stored for
normal operation of the vender. The key switch can
be programmed to control one or several features
simultaneously. If a feature is enabled in this menu, that
feature will override normal machine operation when the
switch is activated.
If <enter> is pressed at the “Over-ride Switch” prompt
the controller will enter the override configuration setting
mode by displaying “Free Vend.” Using <up> or <down>
will allow you to cycle through all available override
configuration options. If <exit> is pressed at any time
during this operation, the controller will return to the
“Over-ride Switch” prompt. From the “Over-ride Switch”
prompt, press <up> to proceed to the final prompt, “Return
to Sales.”
The following options can be selected in the override
selection level:
•
Free Vend
If <enter> is pressed at the “Free Vend X” prompt,
where “X” is the current status (either “1” or “0”), the
display will flash the current status. Pressing <up>
or <down> will cause the flashing status to toggle
between “1” and “0.” When the desired status is
displayed, pressing <enter> will save that status and
return you to the “Free Vend X” display (status no
longer flashing). If “Free Vend” is enabled, “Free”
will be displayed immediately after the POS message.
If X = 0, free vend will be disabled when the key
switch is activated.
If X = 1, free vend will be enabled when the key
switch is activated.
Note: All free vends will increase free vend MIS
counters (VA3).
•
No Vend
If <enter> is pressed at the “No Vend X” prompt,
where “X” is the current status (either “1” or “0”),
the display will flash the current status. Pressing
<up> or <down> will cause the flashing status to
toggle between “1” and “0.” When the desired status
is displayed, pressing <enter> will save that status
and return you to the “No Vend X” display (status
no longer flashing). If “No Vend” is enabled, no
selections will be allowed to vend and a “No Sale”
message will be displayed.
If X = 0, no vend will be disabled when the key switch
is activated.
If X = 1, no vend will be enabled when the key switch
is activated.
Note: If both “Free Vend” and “No Vend” are
enabled, “No Vend” will be given priority (no
vending will be allowed).
•
Sales Block
If <enter> is pressed at the “Sales Block X” prompt,
where “X” is the current status (either “1” or “0”), the
display will flash the current status. Pressing <up>
or <down> will cause the flashing status to toggle
between “1” and “0.” When the desired status is
displayed, pressing <enter> will save that status and
return to the “Sales Block X” display (status no longer
flashing).
If X = 0, selection blocking will be disabled when the
key switch is activated.
If X = 1, selection blocking will be enabled when the
key switch is activated.
Note: “Sales Block” is used in conjunction with
“Select Block X” programming menus.
