9
OPERATING INSTRUCTION
1.
Turn the laminator ON (I) located on the rear of the machine. (Fig. 2)
2.
Choose appropriate laminating thickness and speed. (Fig. 1)
3.
Do not begin laminating until the blinking light is steady (approximately 8 minutes).
4.
Position the item to be laminated on the feed table.
5.
Press the RUN button. The rollers will begin to turn, wait for heat line to disappear,
feed the item into the machine.
6.
Insure the machine drastically cold, press the button in the left cover be “ O ”,then
you can laminate by single side.(It is a damage for the paper to laminate by single
side while the rollers up and low are heating all together.)
7.
Stop the laminator when all of the items have completely exited the rear of the
machine.
8.
Please loose the film tension as loosed as possible.
9.
If there the temperature is high while laminating by some films with thin paper on the
middle temperature level that you can use the low temperature level.
Repeat the above steps until all of your lamination is completed. When lamination is
completed the machine is not in use for an extended period of time turn the power off.
NOTE: Stand by mode and auto power off mode
- Stand by mode: If no activity is made within 30 minutes after each use the
machine will automatically switch into stand by mode. (In stand-by mode the
temperature will decrease to 80~90
and the three film thickness setting
℃
indicators will blink).
- Auto power off mode: If the machine is in stand by mode and no activity is
made for 60 minutes the machine will automatically power off.
- If any activity is made while in stand by or auto power off mode the machine
will return to it’s previous stage.
