Figure 12
▲
LOADING LOWER ROLL FILM
1.
Repeat steps 1-5 to load lower roll film.
2.
Once the upper and lower film is on the shaft, pull the film from the top roll down to
the bottom roll to make certain that the film is aligned properly. Then tighten the
lower locking core screws.
NOTE: If the film is not aligned properly exposed adhesive will adhere to the rollers
and may cause the film to jam.
▲
FILM THREADING
Refer to Figure 6
▲
LAMINATING SINGLE
Press the switch into the location “SINGLE ”.
Figure 13
MAINTENANCE
1.
Do not apply any cleaning fluids to the rollers certain fluids may cause damage.
2.
Do not clean rollers with sharp or pointed objects.
3.
Use adhesive remover to clean resin off of the rollers.
4.
Use a damp cloth with water to clean the body of the machine.
5.
Store machine in a dry clean area.
12