aRp-1314
13
cleaning the unit
1. Turn off the power to the unit and unplug.
2. Wipe down unit with a soft, dry, or damp cloth. A mild detergent can be used.
3. Never use a volatile substance such a gasoline or abrasive cleaners.
4. Do not splash water onto the unit.
Storing the air conditioner
If the unit will not be used for a long time, be sure to drain the air conditioner, clean the air filter, pull out the power supply plug and wrap around power cord hooks, and remove the
batteries from the remote control before storage. After draining, keep the air conditioner running on FAN mode for at least 8 hours to dry the unit completely to prevent mold.
tRoUbleSHootInG
problem
poSSIble caUSeS
SUGGeSted ReMedIeS
Unit does not Start when Pressing
on/off Button
- P1 appears in the display
Drain the water in the bottom tray.
-∙∙∙Room∙temperature∙is∙lower∙than∙the∙set∙temperature.(Cooling∙mode)
Reset the temperature.
Not cool enough
- The windows or doors in the room are not closed.
Make sure all the windows and doors are closed.
- There are heat sources inside the room.
Remove the heat sources if possible.
-∙Exhaust∙air∙duct∙is∙not∙connected∙or∙blocked.
Connect the duct and make sure it can function properly.
- Temperature setting is too high.
Decrease the set temperature.
- Air filter is blocked by dust.
Clean the air filter.
Noisy or vibration
- The ground is not level or not flat enough.
Place the unit on a flat, level ground if possible.
Gurgling sound
- The sound comes from the flowing of the refrigerant inside the air-conditioner.
It is normal.
Power shut off at Heating mode -∙∙Overheat∙function∙has∙activated.∙∙When∙the∙temperature∙at∙the∙air∙outlet∙exceeds∙
70°C/158°F,∙the∙unit∙will∙stop.
Let∙the∙unit∙cool∙down∙and∙then∙restart∙unit.
error code
-
e1:
room temperature error
-
e2:
Evaporator temperature error
-
e4:
Display panel communication error
Unplug the unit and plug it back in. If error repeats, call for service
