For more information, please visit
www.royal-exclusiv.de
. Simply enter the part number or name into
the search box or email:
.
All information subject to change. We try our best, but printing errors reserved.
R
oyal
E
xclusiv
p
umps
&
skimmers
Vorgebirgsstr. 28 // 50389 Wesseling // Germany
Fon +49(0)2236/88055-0 // Fax +49(0)2236/88055-20
[email protected] // www.royal-exclusiv.de
Since 1986
8
8. Possible sources of error
For optimal skimming results,
please note the following information:
1. No water is the same! As a result of the different com-
position, the skimmer may need a few days before it
starts to skim.
(Particularly with new products)
2.
Pay attention to the water filling level between
from ~ 130 mm up to ~ 300 mm (
ideally ~ 210 mm
)
this is the height of the water in the filter basin!
3. The water level in the skimmer is controlled using a
tube. This sets the amount of foam to be produced.
(The
level
of
water in the skimmer
is set by
turning
it
left or right
).
4. If the skimmer produces a water-air mixture in the
tube when it is turned on, this means that the skim-
mer is operating correctly. The skimming default must
lie elsewhere.
5. Do not let the pump run dry -
this would lead
to permanent damage
!
6. A
sufficient pre-filtering
of the water
before
it
en-
ters the skimmer
, is recommended! So, the pump will
be spared as before large parts, such as snail shells
or shells, which can lead to a blockage of the needle
wheel.
For the skimmer to produce optimal results, the Mini Bub-
ble King must be brought to the correct height. This will
depend on the water fill level.
A successfully
assembled Mini Bubble
King 200 RD6.
Don‘t forget to close the
outlet with the silicon plug.
7. Meaning of the LED lights on the Controller
Display red:
Pump has been switched off due to overload
and will be restarted. Needle wheel was blocked by foreign
objects. Pump restarts.
Display green:
Operational, normal operation
When switching on, the LED chain is briefly shut up and
down again.
Water fill
level
240mm
Water fill level
-100mm
Water fill level
-50mm
Do not forget!
At least
20-
30 mm
are required for the
removal and cleaning of
the entire skimmer cup!
