Royal Enfield Rumbler 500 2017, Руководство пользователя

Страница: 143 / 160

57
PRECAUTIONS
 Wash motorcycle when the engine is cold.

Cover the silencer, tail pipe, horn and control
switches with suitable plastic bags and tie it firmly
to prevent water entry.

Remove ignition key and seal key hole using
adhesive tape.

Do not remove right side cover (panel) while
washing to avoid water entry into air filter box
assembly.

Brush engine area with a solvent to remove dirt or
grease.

Use low pressure jet of water to clean.

Never spray water with great force on head lamp,
Meter/cluster unit, flasher lights, front and rear
wheel hubs, electrical connections and wires,
control cables, EFI components, spark plug, battery
air filter cover etc.
 Do not apply any corrosive solvent on painted
surfaces or rubber parts.

Use luke warm water and mild detergent on the
painted components to remove dirt, etc.

Rinse motorcycle thoroughly with plain water to
remove the detergent.

If possible, use compressed air and blow off water
particles from the obscure areas of the motorcycle,
electrical connections etc.
AFTER WASHING
 Ensure, the motorcycle is thoroughly dry by wiping
with a clean soft absorbent cloth or chamois leather.

Remove all plastic bags and adhesive tapes.
 Lubricate control cables, pivots for footrest, side
stand, center stand, brake and gear shifter
linkages, rear chain etc. with lube oil.

Polish the painted (except Stone Black Colour
/ Matt paint finish) and plated surfaces using
polishing wax.

Start engine and allow to run at idling speed for a
few minutes to warm up engine.

Drive the motorcycle slowly, applying both brakes
intermittently to dry up the water in the brake pads.
WASHING PROCEDURE