Roxell Optimax, Инструкция по использованию и сборке

Страница: 74 / 92

OPTIMAX - INSTALLATION INSTRUCTIONS
ROXELL - 004 - 2414
III- 20
Put the auger coil about 4m from the intake boot.
Gradually unroll while giving short pushes to slide the
auger into the tube.
Fix the auger to the drive shaft of the gearhead with
the drive block.
FIGURE 48. FIGURE 49.
4M
Pull the auger until it stretches, then let it relax. Mark
the auger at the edge of the intake boot.
Feed intake boot.
M
Clamp the auger under the drive block.
FIGURE 50. FIGURE 51.
Put the thin edge to-
wards the gearbox.
ALWAYS SEE THAT THE AUGER CANNOT SPRING BACK (BY USING CLAMPS) WHEN YOU
PUT IT UNDER TENSION.
Stretch the auger
1,7cm per 3m tube.
Measure
the required stretch from Mark M to the feed intake
boot. Here you put a new mark NM
Slide the anchor into the auger until the auger
touches the anchor end.
FIGURE 52. FIGURE 53.
Now put a pliers past this mark NM Let the auger
slide back into the tube until the pliers rest against
the feed intake boot.
Firmly tighten the set screw in the middle of the
anchor, so it will expand and clamp the auger.
Cut the auger with a hacksaw or
grinding machine.
NM
M