Panel frame
Floor
Back panel
Side panel
5. Securing the walls to the floor
Ensure the panels are sitting square on the floor. Secure using 16 x 63mm screws, screw through the panel frames and into the floor and floor joists.
Floor joists
50mm
50mm
It is recommended to drill pilot
holes with a 3mm drill for each
screw in this section.
Drill
30mm
4. Apex panels and door header rail and door rebate coverstrips
Place an apex panel on top of the back panel, make sure the bottom shiplap board of the apex panel fits correctly into the shiplap board of the back panel. Secure by using
2 x 50mm screws, screw up through the top frame of the back panel into the bottom frame of the apex panel. Repeat for front apex. Attach to the front apex the door
header rail using 2 x 50mm screws. Secure it flush to the bottom of the apex framing as shown. The door frame coverstrips are positioned between the floor and the
header rail. Attach the coverstrips flush to the framing of the front panels using 4 x 30mm nails per strip.
6. Roof sections
To the first roof panel secure a roof rafter flush to the right-hand edge of the panel, ensure the correct angled end of the rafter is flush to the short edge of the panel as
shown below. Attach using 4 x 30mm nails, nail through the panel into the rafter. To the second panel attach two rafters in the same way as the first with one down each
side of the panel. To the third panel attach a rafter down the Left-hand edge. Join the three panels together using 2 x 50mm screws per join, Screw through the rafter of
one panel into the rafter of the next as shown. Create a second roof section in the same way as the first.
Ensure rafters
are flush to
the edge of
the panel.
Ensure rafters
are flush to
the edge of
the panel.
Panel 1
Panel 2
Panel 3
Ensure correct
orientation of
angled ends.
30mm
50mm
50mm
50mm
63mm
63mm
63mm
