50mm
Floor
Panel frames
rest on floor.
50mm
panel cladding
overhangs floor
edge.
It is recommended to drill pilot holes
with a 3mm drill for each screw.
Drill
Side panel
Fr
o
n
t p
an
e
ls
Large plain panel
Small
panel
Back panel
Large plain panel
50mm
50mm
3. Fixing the wall panels together
Position a large plain panel and a small panel as shown. Note how the panel frames sit on the floor with the panel cladding overhanging the floor edge. Ensure square and
secure using 3 x 50mm screws, screw through the frame of the small panel, into the frame of the large panel. Continue to add panels as shown below securing each one
with 3 x 50mm screws.
Assembly tip.
The window panels
can be interchanged
with any of the large
panels on the
building.
Window panel
Window panel
Small
panel
1. Laying the floor section
Prepare a level area for the shed to sit of no less than 1870mm x 2450mm. With the three floor panels upside down, join together using 5 x 50mm screws as shown.
25mm
25mm
25mm
View from inside
of window
38mm
2. Fitting the windows
For the opening window, lay a window panel on the floor. Fit two storm proof hinges in the rebates on the longer edge of the window as shown in the diagram using
3 x 25mm screws per hinge, stand the hinge end of the window on the window panel, making sure it is centred at the top of the window opening. Open the hinges and
secure them to the window panel frame using 3 x 25mm screws per hinge. On the inside of the window panel fit the window stay and its two posts using 6 x 25mm screws
as shown in the diagram. For the fixed window, Put the window frame into place on the other window panel, secure into place using 4 x 38mm. Screw through the side
of the window frame into the framework of the window panel.
Opening window
Fixed window
Secure the hinges
to the longer edge
Important note
To
"VALIDATE"
the guarantee, adequate provision must be made to ensure ground
contact is avoided and air is able to circulate underneath the building.
Placing the building on a concrete pad or slab base is acceptable provided that the
building is not allowed to sit in pooled water during wet conditions.
If the building is to sit on soil or grass it
MUST
be erected on pressure treated
wooden 50mm x 50mm or similar bearers
(These are not supplied in the kit).
Rowlinson Garden Products recommend using pressure treated bearers with all
buildings on any type of base.
It is recommended
to drill pilot holes
with a 3mm drill
for each screw.
Drill
Use this diagram to check the
correct orientation of the corners
Important
