50mm
It is recommended to drill pilot holes
with a 4mm drill for each screw.
Drill
50mm
50mm
It is recommended to drill pilot
holes with a 4mm drill for each
screw in this section.
Drill
2. Fixing the wall panels together
Position two medium panels as shown. Note how the panel frames sit on the floor with the panel cladding overhanging the floor edge. Ensure square and secure using
3 x 50mm screws, screw through the frame of the back panel, into the frame of the side panel. Continue to add panels as shown below securing each one with 3 x 50mm
screws.
Assembly tip.
The window panels can
be interchanged with any
of the large panels on the
building.
1. Laying the floor section
Prepare a level area for the shed to sit. Attach three treated wooden or similar bearers of size 50 x 50 x 1520mm to each floor panel (Not supplied in kit). Position the
floor on the prepared area and enure level.
30mm
3. Apex panels,door header rail and door frame coverstrips
Place an apex panel on top of the back panel, make sure the bottom shiplap board of the apex panel fits correctly into the shiplap board of the back panel. Secure by using
2 x 50mm screws, screw up through the top frame of the back panel into the bottom frame of the apex panel. Repeat for front apex. Attach to the front apex the door
header rail using 2 x 50mm screws. Secure it flush to the bottom of the apex framing as shown. The door frame coverstrips are positioned between the floor and the
header rail. Attach the coverstrips flush to the framing of the front panels using 4 x 30mm nails per strip.
Fr
ont panels
Large plain panel
Medium
panel
Medium panel
Window panel
Small
panel
Medium panel
Panel frames
rest on floor.
50mm
panel cladding
overhangs floor
edge.
Side panel
Back panel
To "
VALIDATE
" the guarantee, this item should be erected on 50mm x
50mm treated wooden or similar bearers
(These are not supplied
with the kit.)
Ground contact must be avoided.
