26/44
GB
Attention danger!
Wait until appliance has cooled down
before covering or putting it away.
4.6 Repacking for private
transport purposes
Always pack the appliance in its original
packaging for transportation to prevent
transport damage.
5. Cleaning and Mainte-
nance
5.1 Safety measures
X
Always pull the mains plug out of the
socket before servicing the appliance.
X
Only begin the maintenance or repair
work once the appliance has completely
cooled down.
X
Cleaning and maintenance: this may
not be carried out by children without
supervision.
5.2 Cleaning
The ceramic fan heater should be covered
after each use to prevent contamination
by impurities.
Attention danger!
Wait until appliance has cooled down
before covering or putting it away.
If the appliance has nevertheless become
dirty, observe the following notes during
cleaning:
X
Always clean the appliance while cool.
X
Pull out mains plug before any work.
X
Only clean the appliance with a dry,
soft cloth. Never use strong and/or ab
-
rasive cleaning agents.
5.3 Maintenance
Note that only original parts may be
used for repair and maintenance work.
Contact the
ROWI
Service Center if need
be (see Chapter 6).
5.4 Troubleshooting
FAULT: Appliance does not start.
Possible cause
Remedy
No power or
voltage too low.
Make sure the
plug is plugged
into the socket.
Check the power
supply voltage.
The appliance is
not switched on.
Move the heating
level switch to
position “I” or “II”.
The room tempe
-
rature is above the
temperature set at
the thermostat.
Increase thermos
-
tat temperature.
The tip protection
switch has
triggered
Make sure the
appliance is in a
vertical position
and not exposed
to any extreme
inclination.
FAULT: The switch switches off during
operation.
Possible cause
Remedy
The thermal pro
-
tection switch has
triggered. The
appliance has
exceeded the
maximum
permissible
temperature.
Switch off the
appliance by
moving the
heating level
switch to position
"0" and pull the
plug out of the
socket. Allow
the appliance to
