11
voltage other than as stamped on the product, or a modification or unauthorised repair of the product. it also does not cover normal wear and tear,
maintenance or replacement of consumable parts, or the following:
- using the wrong type of water or consumable
- scaling (any de-scaling must be carried out according to the instructions for use)
- ingress of water, dust or insects into the product
- mechanical damages, overloading
- damages or bad results due to wrong voltage or frequency
- accidents including fire, flood, thunderbolt etc
- professional or commercial use
- damage to any glass or porcelain ware in the product
- stains due to hair colouring products
this guarantee does not apply to any product that has been tampered with, or to damages incurred through improper use and care, faulty packaging by
the owner or mishandling by any carrier.
the international rowenta guarantee applies only for products used in any of the listed countries where the specific product is sold.
Consumer Statutory Rights
this international rowenta guarantee does not affect the statutory rights a consumer may have or those rights that cannot be excluded or limited, nor
rights against the retailer from which the consumer purchased the product. this guarantee gives a consumer specific legal rights, and the consumer may
also have other legal rights which vary from state to state or country to country. the consumer may assert any such rights at his sole discretion.
6. IN CASE OF PROBLEMS
7. ENVIRONMENTAL RESPONSIBILITY
your appliance contains materials which can be re-used or recycled.
leave it at a local civic waste collection point.
HAIR IS NOT PROPERLY SMOOTHED:
• Did you use the straightener in the correct direction? (steam output to the tips of the hair)
• Did you dry the hair 100% before use?
• have you selected the correct temperature? (see table on temperature ranges)
• Does the tool emit steam? no
• have you correctly filled the tank?
• if the water is below the minimum level, fill the tank and close the straighteners until steam is generated.
• have you properly inserted the tank into the base until it clicks?
• is the tool temperature level set? wait for the number of the chosen temperature to stop flashing.
• check that the steam cord is not accidentally blocked, twisted or knotted.
STEAM IS NOT VISIBLE:
• in high humidity, it may be that the steam is not visible but is still effective.
THE TOOL DOES NOT HEAT UP:
• have you checked that the appliance is not in power save mode?
ALL THE TEMPERATURE LIGHTS FLASH SIMULTANEOUSLY:
• if all temperature lights flash simultaneously, take your appliance to an approved service centre.
TOP STRAIGHTENING PLATE IS NOT FIXED:
• this is normal, the device is equipped with a floating plate for better smoothing efficiency.
APPLIANCE EMITS WATER FROM THE STEAM OUTLETS:
• take your appliance to an approved service centre.
APPLIANCE IS LEAKING:
• unplug immediately and take your appliance to an approved service centre.
All manuals and user guides at all-guides.com
all-guides
.com
