Rowenta DR71 Series, Руководство пользователя

Страница: 8 / 49

15 14
Before first use
• When you first use the appliance, some smoke or a harmless odour may be produced or there may be a small
discharge of particles. This will not affect the use of the appliance and will disappear quickly.
What water to use?
• Your appliance has been designed to use tap water.
If your water is very hard (hardness above 30°F, or 17°dH or 21°e), mix 50% tap water and 50% bottled
demineralised water. Never use water containing additives (starch, perfume, aromatic substances, softeners, etc.), or
condensation water (for example water from tumble dryers, water from refrigerators, water from air conditioning
units, rainwater). Do not use pure distilled nor pure demineralised water. Such water contains organic waste
materials or minerals that concentrate under the effect of heat and cause spitting, brown colouring or premature
ageing of your appliance.
SAVE THESE INSTRUCTIONS
Environment protection first !
i Your appliance contains valuable materials which can be recovered or recycled.

Leave it at a local civic waste collection point.
Problems with your iron?
* Depending on model
PROBLEM POSSIBLE CAUSES SOLUTIONS
There is no steam. The appliance is not plugged in, or
not switched on.
Check that your appliance is correctly
plugged in and switched on.
The water level is too low. Unplug your appliance and refill it.
The steam pump has not been
primed.
Press the steam trigger continuously
until the steam appears.
You are using the appliance for the
first time.
Press the steam trigger continuously
until the steam appears.
The water tank is not fully in place. Ensure that inlet stopper is closed
and that the water tank clicks/locks
when put into place.
The appliance does
not heat.
It is not plugged in, or not swit-
ched on.
Plug in your appliance and switch on.
Water leaks. The water tank is not fully in place or
the stopper is not closed properly.
Ensure that inlet stopper is closed
and that the water tank clicks/locks
when put into place.
Steam rate decreases. Calc has built up in the appliance. Refer to ‘ANTI CALC section in
instructions for use.
The steam leaves stains
on the fabric or the
appliance spits.
You are using water with additives. Never add any additive in the water
tank.
Refer to ‘‘WHAT WATER TO USE’’
section.
The appliance has not been rinsed
enough after the descaling
operation.
Read carefully the ‘ANTI CALC’ section
in instructions for use.
You are using other liquids than
white vinegar to descale the pro-
duct.
Use only white vinegar during ‘ANTI
CALC’ procedure.
Refer to the ‘‘ANTI CALC’’ section in
the instructions for use.
Micro fiber brush
*
support is removed from
the steam head / from
the micro fiber brush
support .
You scrub too tightly the textile. Scrub softly the textile to remove
inpregnated dust.