Rowe GrandSTAR, Руководство по обслуживанию

Страница: 58 / 120

LED Lighting and Bill Acceptor Grand STAR Internet Jukebox
5-2 22022603
Flash Rate (Speed) of the LEDs
The flash rate (speed) can be adjusted from very rapid to approximately every two seconds.
To adjust the flash rate with the IR Remote, push SPEED, then push to make the flash
rate faster, or push LIGHTS-
-
to make the flash rate slower. When the high and low limits of the
flash rate are reached, the IR Receiver Red LED stays ON.
To adjust the flash rate using the SPEED pot on the LED Control Assembly 40931103, turn the
control counterclockwise to make the flash rate faster, and clockwise to make the flash rate slower.
Brightness of the LEDs
The brightness can be adjusted from very dim to full brightness.
To adjust the brightness with the IR Remote, push BRIGHT, then push to make the LEDs
brighter. Or push LIGHTS – to make the LEDs dimmer. When the high and low limits of the
brightness are reached, the IR Receiver Red LED stays ON.
To adjust the brightness using the BRIGHTNESS pot on the LED Control Assembly 40931103, turn
the control counterclockwise to make the LEDs brighter, and clockwise to make the LEDs dimmer.
Music Beat Sensitivity
There are three adjustments that affect the Music Beat Sensitivity. The IR Remote Music Control
Switch, the Music Pot, and the Speed Pot (the last two are on the LED Control Assy 40931103).
The faster the Speed Pot is set, the less influence music will have on the LED lighting. It is
recommended to have a relatively slow speed setting so the music will have a greater influence on
the patterns.
To initially adjust the Music Beat Sensitivity, make a selection, and when you hear the music, push
MUSIC on the IR Remote; then push and hold until the IR Receiver Red LED stays ON.
This sets the IR Music Control to maximum sensitivity. Now, on LED Control Assembly 40931103,
rotate the Music and Speed Pots fully clockwise. The LED Display flash rate should vary to the
music. Slowly turn
the Music Pot counterclockwise until you see the desired effect of the music beat
on the pattern. Once this pot is set, the remote may be used to reduce the effect of the music on the
LEDs.
After the initial adjustment has been made, you can vary the Music Beat Sensitivity using the IR
Remote Control. To do this, push the MUSIC, then push to increase music sensitivity, or
push LIGHTS- to decrease music sensitivity. When the high and low limits of the music sensitivity
are reached, the IR Receiver Red LED stays ON This adjustment is very sensitive. A slight
adjustment causes a relatively large change to music sensitivity.
Remote Enable/Disable Program Switch
Program DIP Sw #3 controls the IR Remote Control Enable/Disable feature (See Figure 5-3 ).
Sw#3 is ON to Enable: OFF to Disable