Rowe GrandSTAR, Руководство по обслуживанию

Страница: 25 / 120

Grand STAR Internet Jukebox Installing Hard Drive & Testing
22022603 2-5
Testing the Unit
Once the jukebox is powered on and the user interface is running (see
Figure
2-7
- Jukebox User Interface ) , try the following procedures before moving and
installing the unit at the venue:
Touchscreen
NOTE: Every time a hard drive is installed in a Core Computer, the touch-screen should be
calibrated.
The following procedure describes how to calibrate the touch-screen:
1. Press the “Calibrate” button on the Rowelink Controller ( Figure 2-5) . Press the
button in once to launch the calibration program. This will override the Jukebox
application while the calibration program runs. (See
Figure 2-6 for a picture of the
calibration program interface.)
2. Follow the directions on the screen, touching the center of the targets, then touching
“YES” .
Calibrate
TB1
ROWELINK
P6
P7
P9
P5
P8
P10
POWER OUT
P23
P14
POWER IN
POWER IN
12 VDC
24 VDC
24 VAC
5 VDC
RS232
P22
CC RL RX
CC RL TX
P21
COIN
ACCEPTOR
P20
COIN
SWITCHES
P19
BILL
ACCEPTOR
POWER CALIBRATE SERVICE
REJECT
ROWELINK CONTROLLER
409260XX
P3
AMP MUTE
P11
IR DETECTOR
P12
SW'S
P17 P18
COUNTER MDB
BILL
ACC.
POWER
P16
CRDT STATUS
KID RL TX
CRDT RL TX
IR RCV
1000 W
250 W
P15
REJECT
P4
FAN CKTS
P2
VIDEO SW
Figure 2-5 - Rowelink Controller Figure 2-6 - Calibration Screen
3. If you’ve installed a Hard Drive which had previously been connected to the AMI
Network, skip ahead to Step 4. Raise the jukebox door again and press the
“Service” button on the Rowelink Controller (see Figure 2-5). Lower the door and
touch “Location/System Setup”, then “Enable/Extend Features “. Using the on
screen keyboard, enter the Trigger Code written on the Card which was included
with your new Hard Drive. Touch ENTER to complete the process – the message
“Valid Trigger Code Entered” will be displayed on the screen. Press “Main Menu”
and then “Exit Service Mode”. The system is now prepared for connection to the
AMI server.
4. Close the jukebox door and make sure that it is locked.