Rover Seventy Five, Руководство пользователя

Страница: 183 / 209

Bulb Replacement
182
NOTE: Replacing the outboard
headlight bulbs must be done by
‘feel’ and, in the most part, with
one hand only.
When removing the bulb, the following tips will make the
job easier.
•
Always remove the electrical connector BEFORE
unhooking the wire securing clip.
•
Examine the illustration carefully to see how the wire
securing clip works.
•
Before replacing the electrical connector, refer to the
illustration to check which way round the connector needs
to be to enable it to fit onto the spade-type contacts on the
bulb.
Replacement of the bulb is a reversal of the removal process.
Sidelight
Replacement bulb: 5 watt.
The sidelight holder is immediately below the headlight bulb.
With the circular rubber cover removed, pull the bulb holder
from the light unit and pull the bulb to remove from the
holder.
Replacing the access panel
Clip the protrusion at the top of the access panel into the
aperture in the wheelarch liner and push the panel upwards as
far as it will go. The smaller protrusion at the bottom of the
panel can then be clipped into the corresponding cut-out at
the bottom of the wheelarch liner aperture. Finally, engage
the turnbuckle screw and turn a quarter turn to left or right
to fully secure the access panel.