Rover 75 Saloon, Руководство пользователя

Страница: 43 / 285

Heating & Ventilation
43
1
While the controls can be adjusted manually to satisfy individual
requirements, allowing the system to function automatically (in
Auto mode) is by far the simplest method of operation for the
owner and is preferable in most operating conditions.
In Auto mode, air temperature, air distribution and blower speeds
are adjusted automatically to achieve and then maintain the desired
temperature.
NOTE: In Auto mode, following a cold start at low exterior temperatures,
the blower speed will not increase until the engine coolant temperature has
started to rise.
Both the air distribution and blower controls can be operated
independently to override the automatic setting. In this case, the
relative symbols will move outside the enclosed central area of the
display, to indicate that they are no longer controlled
automatically.
NOTE: For ATC to function correctly, all windows (and sunroof) should
be closed and the air intake must be free from obstructions (ice, snow, leaves
and other debris). In addition, the solar sensor centrally positioned on the
top of the fascia panel must not be covered.
Temperature control
Operate the rocker switches on either side of the display to set the
required temperature for the corresponding side of the passenger
compartment (left hand switch for the left side of the car, and right
hand switch for the right side). The system will not achieve
temperatures on the passenger side of the car more than 5° C
greater or less than the temperature set for the driver's side.
Temperatures above 28° C and below 16° C cannot be set. Above
or below these maximum and minimum settings ‘HI’ or ‘LO’ will
appear in the display.
NOTE: The temperatures shown on the display are target temperatures
only and are not reflective of any specific temperature measured within the
interior of the car.
Defrost
Press the button at the beginning of a journey to clear
frost or mist (the indicator in the switch illuminates and
the defrost symbol, along with the blower symbol, appears in the
display).
The defrost facility automatically activates the following:
•
The most efficient heater settings to clear the windscreen and
front side windows.
•
The heated rear screen - for a maximum of 20 minutes.
Press the button again to cancel defrost and restore the original
settings, or press ‘Auto’ to go straight into Auto mode.