Cleaning
1. Remove driver assy. and wash in hot detergent
water. Rinse in clear water.
2. Clean stainless steel top with damp cloth, rinse,
and dry with clean cloth.
These simple cleaning procedures should be per-
formed after every use. To maintain the overall cleanli-
ness of the carousel and to prevent unwanted dust
from accumulating on the surface, cover the carousel
when not in use.
CORN CAROUSEL
6
P/N 1010730 10/99
A.J. Antunes & Co.
POWER
OFF
100
120
140
160
180
200
Figure 2. Controls
Rocker Switch
(Power On/Off)
Temperature
Control
Hi-Limit Switch
Operating Instructions
1. Turn the rocker switch to the ON position.
2. Place the desired amount of butter or margarine
onto the stainless steel base.
3. Set the temperature control to the desired setting.
4. Wait approximately 15 minutes for the butter or
margarine to melt before placing the cooked corn
cobs between the driving arms.
NOTE: When butter/margerine has melted, depth
should not exceed 1/4".
IMPORTANT: The kernels may flatten out when
corn is allowed to stay in the carousel for a long
period of time. To prevent this, reduce the number
of ears placed in the carousel during slow periods..
It is recommended that corn not be kept in
carousel longer than 1-1/2 hours.
Hi-Limit Reset Button
A hi-limit thermostat will turn off electrical power to the
heater and control circuits if the unit overheats. To
reset this thermostat, allow sufficient time (10-15 min-
OPERATION
WARNING
Turn the unit off, disconnect the power source
and allow the unit to cool down before performing
any service or maintenance on the unit.
MAINTENANCE
CAUTION
To prevent damage to the unit, do not use abra-
sive cleaners on the unit.
Replacing Components
NOTE: It is recommended that all service procedures
be performed by a qualified authorized service techni-
cian.
NOTE: Reference numbers in procedures correspond
to replacement parts on pages 10-11.
POWER CORD REPLACEMENT
1. Turn off rocker switch (power on/off), unplug the
power cord and allow the unit to cool down before
proceeding.
2. Remove the adjustable legs (23), base plate (22)
and insulation (21).
CAUTION
Do not tilt unit on its side to drain butter or mar-
garine. This will cause premature part failure due
to seepage into the interior components.
utes) for the unit to cool down, then depress the reset
button located on the bottom of the unit (Figure 2).
If hi-limit thermostat requires continuous resetting,
contact your Roundup Authorized Service Agency
for service.
