CORN CAROUSEL
7
P/N 1010730 10/99
A.J. Antunes & Co.
3. Disconnect power cord wires from terminal block.
4. Remove strain relief nut (15) from outside of unit .
5. Squeeze strain relief and pull cord out.
6. Remove nut from inside of unit and remove strain
relief.
7. Reverse steps 2-6 to install new power cord
and/or strain relief.
DRIVE MOTOR REPLACEMENT
1. Turn off rocker switch (power on/off), unplug the
power cord and allow the unit to cool down before
proceeding.
2. Remove the driver assy. (1). Unscrew the two
screws (3) from top of the grill cone (4). These
screws secure the motor mounting bracket to the
inside of the cone.
3. Carefully turn unit over. Remove the adjustable
legs (23), base plate (22) and insulation (21).
4. Disconnect the wires and carefully remove drive
motor and bracket assembly.
5. Remove drive motor (10) from mounting bracket
(9).
6. Assemble replacement motor to bracket and con-
nect replacement motor wires.
7. Place the motor into the cone recess and align
mounting holes. Carefully tilt the unit on end and
secure motor with original screws (3).
NOTE: Make sure grommet (s) is properly seated in
cone.
8. Re-install insulation, base plate and legs.
9. Re-install driver assy.
10. Check for proper operation before placing unit
into service.
FAN REPLACEMENT
1. Turn off rocker switch (power on/off), unplug the
power cord and allow the unit to cool down before
proceeding.
2. Remove the driver assy. (1). Unscrew the two
screws (3) from top of the grill cone (4). These
screws secure the motor mounting bracket to the
inside of the cone.
3. Carefully turn unit over. Remove the adjustable
legs (23), base plate (22) and insulation (21).
4. Carefully pull fan from drive motor shaft.
5. Install replacement fan onto motor shaft with
metal spring toward housing. Fan must be all the
way onto shaft to allow clearance below to base
plate.
Make sure all wires are clear so fan blade rotates
freely.
NOTE: Fan should slide on with finger pressure. If fan
is too tight of a fit, drill fan hole bore to suit diameter of
motor shaft.
CAUTION
Do not use excessive force or hammer to mount
fan or damage to internal gear train will occur.