to the 3-pin female connector and tighten screws to secure wires; use pin 1or 3 for video and 2 for ground.
Insert female connector into the 3-pin connector (P8) on the PC board. This signal is polarized and specific
wire connection is necessary. See Table below.
Twisted Pair Connections (P8)
Pin Number
Function
1 Video
2 Video
GND
3 Video
Figure 5A
Camera/Lens PC Board (Coaxial and UTP versions)
Fiber
Video is brought into the unit via the fiber cable connected to a standard ST connector on the board (U4). A
video focus adjustment connector is provided on the camera board for use with a portable/local monitor for
making adjustment. On the fiber version, a second connector is provided on the PC board (J4) for use with a
portable/local monitor for making video adjustment. A video adjustment cable is supplied in the accessory kit
for adjusting the focus. Connect one end of this cable to J4 and the BNC connector to the camera. Refer to
Figure 5B.
Figure 5B
XX137-60-00 Rev 109 Roughneck V910 Dome Cameras with WDR
5BInstallation
•
7
