ROTORCOMP EVO15, Руководство по эксплуатации

Страница: 23 / 36

Operating Manual -
EVO ®
Line
[en] 07/2020 7.3
7.3.2 Oil drain point
The system should be at operating temperature in
this case.
Note:
Dispose of the used oil according to the applicable
regulations
• Switch off the screw compressor air end with
the main switch and selector switch and secure
against being switched on again.
• Completely release the pressure in the screw
compressor air end system.
• Slowly unscrew the screw plug on the oil filler
opening.
• Carefully unscrew the oil drain screw and catch
the used oil in a suitable container.
• Clean the oil drain screw and screw in again.
7.3.3 Filling with oil
Caution:
Observe the oil recommendation, see "Lubricants
and Operating Materials". Add oil of the same oil
type and the same brand.
A conversion to another oil type may require flush-
ing of the compressor module.
ROTORCOMP recommends also replacing the oil
filter during an oil change.
• Replace the oil filter if necessary.
• Pour oil into the filler neck on the separator tank
up to the maximum level and screw the screw
plug onto the filler neck by hand.
• Switch on the screw compressor and allow it to
run for approx. three minutes.
• Oil level check:
Top up the missing oil quantity again up to the
maximum level.
• Check sheet entry (see chapter 7.4 "Mainte-
nance check sheet").