1
x
Safety
6
FA ROTEX Solaris RPS3 25M - 03/2010
Handling instructions
•
Handling instructions are shown as a list. Actions for which the sequential order must be maintained are numbered.
Results of actions are identified with an arrow.
Validity
Some of the information in this manual only applies to certain components or software versions of the RPS3 25M differential
temperature controllers. Validity is indicated by the following symbols:
1.3
Avoiding danger
ROTEX Solaris systems are state-of-the-art and are built to meet all recognised technical requirements. However, improper use
may result in serious physical injuries or death, as well as property damage. To avoid danger ROTEX Solaris systems should only
be installed and operated:
– as stipulated, and in perfect condition,
– with an awareness of safety and the hazards involved.
This assumes knowledge and use of the contents of this manual, of the relevant accident prevention regulations as well as the
recognised safety-related and occupational health rules.
1.4
Intended use
The ROTEX Solaris system may only be used for solar-supported heating of hot water heating systems. The ROTEX Solaris
system must be installed, connected and operated according to the information in this manual.
Any use other than or beyond that defined is considered to be improper. Any resulting damages will be borne by the user/owner
alone.
Intended use also includes compliance with the maintenance and service conditions. Replacement parts must at least satisfy the
technical requirements defined by the manufacturer. This is the case, for example, with original spare parts.
1.5
Instructions for operating safety
Working on the roof
•
Installation work on the roof may only be carried out by authorised and trained persons (heating technicians, roofers, etc.)
under observance of the relevant Accident Prevention Regulations.
•
Material and tools must be secured against falling.
•
Barriers must be erected to prevent persons from entering the area below the roof where the work is being carried out.
Before working on the heating system
•
All work on the heating system (such as installation, connection and commissioning) may only be carried out by authorised
and trained heating technicians.
•
Switch off the main switch and secure it against unintended switching on when carrying out any work on the heating
system.
Electrical installation
•
Electrical installation should only be carried out by qualified electrical engineers observing the technical electrical guidelines
and regulations of the relevant electric power supply company.
•
Before connecting to the mains supply, check that the voltage specified on the type label of the heating system (230 V,
50 Hz) is the same as the available supply voltage.
Instructing the user/owner
•
Before you hand over the Solaris system, explain to the user/owner how to operate and check the system.
•
Document the handover by filling out the installation and instruction forms together with the owner and sign them.
Valid for all software versions of the Solaris R3 con-
troller
Only valid for the specified software version of the Solaris
R3 controller
3.9
3.9
